Zodiac TRI CHLORINE GENERATOR Guide d'installation télécharger pdf (Page 16)

Maintenance

To keep your TRi appliance in the best condition we recommend that you maintain it regularly.

Inspecting and cleaning the electrode

In zones where the water is hard (high TH) the Tri electrode may have to be cleaned.

To clean the TRi electrode:

1. Turn o the TRi chlorinator and the ltering, close the isolation valves and remove the cell cap.

2. Unscrew the retaining ring and remove the electrode from the cell body. e ring is crimped allowing the use of

a lever in case it gets stuck.

If scale is present place the electrode in cleaning solution without immersing the connection terminals.

3. If you are not using a commercial cleaning solution you can make your own by carefully mixing one (1) part of hydrochloric

acid with nine (9) parts of water (Warning: always pour the acid into the water, never the opposite!). A stronger solution would

reduce the electrode’s life span.

4. Let the cleaning solution dissolve the scale deposit for about een minutes. Dispose of the solution in an approved local waste

collection centre; never pour it into the rain water evacuation system or into the sewers.

6. Rinse the electrode in clean water and replace it in the cell body (there is an alignment failsafe).

7. Replace the retaining ring, reconnect the cell cable and replace the cap. Switch ltering and the Tri chlorinator on.

8. Conrm chlorine production and operating seings on the command box. e clock seings are saved automatically.

IMPORTANT NOTE: If the water is too hard (TH > 40 °f (400 ppm)), it is possible to alter the length of the

polarity inversion cycles on your TRi chlorinator in order to obtain a beer self-cleaning eect on the electrode.

If this is the case contact your reseller (professional access).

1 2 ... 11 12 13 14 15 16 17 18

Pas de commentaire

Zodiac TRI CHLORINE GENERATOR Guide d'installation Page 16